Track Power Accesories

NYRS Turntable Track Power Module

The NYRS track power system transfers electrical power to the bridge rails through a pair of printed circuit boards and spring-loaded contacts. The bridge does not rely on the circular rail around the pit for electrical pickup. This does not change polarity on bridge movements. (Coming soon for Diamond Scale Turntables)

How it works

A commutator PCB mounted underneath the bridge has concentric gold contact rings. Wires from the two bridge rails pass through the bridge and are soldered to the PCB. A stationary contact PCB mounted in the center of the pit has four spring-loaded contacts that press lightly against the rotating contact rings.

   Bridge commutator PCB with concentric contact rings.
  Stationary PCB and spacer with four spring-loaded contacts. Connect track power to the PCB pads labeled J1.
Contact pins mounted in the pit around the motor shaft.

Bridge installation

The bridge fits onto the motor’s 5 mm shaft, which has a flat matching the bridge socket. The bridge is lowered until the spring contacts are compressed slightly, providing electrical contact without bottoming out the pins. The bogie wheels should rest lightly on the circular rail.

Assembled turntable bridge installed in the pit
Bridge installed in the pit.

Installation check: Before applying power, check continuity from each bridge rail to its corresponding commutator contact and confirm the two rails are electrically isolated from one another

Bridge installation

The bridge fits onto the motor’s shaft. The bridge is lowered until the spring contacts are compressed slightly, providing electrical contact without bottoming out the pins. The bogie wheels should rest lightly on the circular rail.

Scroll to Top